Chief SSM169 manual

Chief SSM169
(1)
  • Number of pages: 1
  • Filetype: PDF
  • INSTALLATION INSTRUCTIONS

    Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
    no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
    of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
    implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
    Chief Manufacturing, a products division of Milestone AV Technologies
    8401 Eagle Creek Parkway, Savage, MN 55378
    • P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
    8802-000237 RevB
    ©2009 Milestone AV Technologies,
    a Duchossois Group Company
    05/09

    Installation Instructions

    WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing Interface bracket.
    NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
    1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
    2. Place felt pads on inner corners of top and bottom to protect projector.
    3. Align Bracket B threaded holes with slots in Bracket A, and install the 10-24 x 1/4" screws loosely enough so brackets slide in the slot.
    4. Turn projector upside down.
    5. Slide bracket assembly open and slide the projector into Bracket A.
    6. Slide Bracket B in until both brackets are touching projector.
    7. Place the bracket assembly onto bottom of projector and align the holes in bracket assembly with the threaded inserts in bottom of
    projector. Tighten all fasteners at this time, securing the bracket to the projector.
    NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
    All-Points Security Kit.
    Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.

    SSB-169, SSM-169, SLB-169 and SLM-169 Interface Brackets

    SSB-169, SSM-169, SLB-169 and SLM-169 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the
    specific installation instructions provided with the mount for additional installation information.
    Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
    WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY
    AND DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
    (1) Interface Bracket A (8) PAD, Felt
    (1) Interface Bracket B (2) Screw, Phillips Pan Head, 10-24 x 1/4"
    (4) 10-24 Thumb Nuts ** (1) All-Points Security Kit
    **Only used when installing SLB/SSB interface brackets.
    NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
    encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-
    style interface bracket installation.
    SLB-169SLM-169 Felt Pad(8 places) Felt Pad(8 places)Bracket ABracket B
    Bracket B
    Bracket A
    Towards front of
    projector
    Towards front of
    projector
    (No
    te: SS
    M-sty
    le inte
    rface
    brack
    et conn
    ectio
    n
    s
    a
    r
    e
    e
    n
    i
    e
    d
    )
    (N
    ote: S
    SB-st
    yle int
    erface
    brack
    et con
    nectio
    ns
    a
    r
    e
    e
    n
    c
    i
    r
    c
    e
    d
Chief SSM169

Got a question?

Number of questions: 0

Do you have a question about the Chief SSM169 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Chief SSM169 owners to properly answer your question.

View the manual for the Chief SSM169 here, for free. This user manual comes under the category Projector accessories and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Chief SSM169? Ask your question here

Chief SSM169 specifications

General
Brand Chief
Model SSM169
Product Projector accessory
Language English
Filetype PDF
Features
Brand compatibility Casio
Product colour Black
Compatibility XJ-S30/S35
show more

Frequently asked questions

Below, you will find the most frequently asked questions about the Chief SSM169.

Is your question not listed? Ask your question here