Chief SSM225 manual

Chief SSM225
(1)
  • Number of pages: 1
  • Filetype: PDF
  • INSTALLATION INSTRUCTIONS

    Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
    no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
    of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
    implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
    Chief Manufacturing, a products division of Milestone AV Technologies
    8401 Eagle Creek Parkway, Savage, MN 55378
    • P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
    8850-000149 Rev01
    ©2009 Milestone AV Technologies,
    a Duchossois Group Company
    05/09

    SSB-225, SSM-225, SLB-225 and SLM-225 Interface Brackets

    SSB-225, SSM-225, SLB-225 and SLM-225 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
    installation instructions provided with the mount for additional installation information.
    Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
    WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

    Installation Instructions

    WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
    NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
    1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
    2. Turn projector upside down on a flat surface.
    3. Place 1/4" spacers over threaded inserts in bottom of projector.
    4. Place interface bracket onto projector and align spacers with mounting holes.
    5. Attach interface bracket to projector using M4 x 16mm Phillips pan head screws and flat washers. Tighten all fasteners at this time,
    securing the bracket to the projector.
    NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
    instructions in the All-Points Security Kit.
    Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
    (1) Interface Bracket (4) Screw, Phillips Pan Head, Machine, M4 x 16mm ****
    (4) 10-24 Thumb Nuts ** (4) Washer, Flat, M4
    (1) All-Points Security Kit (4) 1/2" x .218" x 1/4" Nylon Spacer ****
    **Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.
    NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
    encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
    interface bracket installation.
    SLB-225 SLM-225
    (
    N
    o
    t
    e
    :
    S
    S
    -
    s
    t
    y
    l
    e
    i
    n
    t
    e
    r
    f
    a
    c
    e
    b
    r
    a
    c
    k
    e
    t
    c
    o
    n
    n
    e
    c
    t
    i
    o
    n
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
    (
    No
    te: SS
    B-sty
    le i
    n
    t
    e
    r
    f
    a
    c
    e
    b
    r
    a
    c
    k
    e
    t
    c
    o
    n
    n
    e
    c
    t
    i
    o
    n
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
    Towards front of
    projector
    Towards front of
    projector
Chief SSM225

Got a question?

Number of questions: 0

Do you have a question about the Chief SSM225 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Chief SSM225 owners to properly answer your question.

View the manual for the Chief SSM225 here, for free. This user manual comes under the category Projector accessories and has been rated by 1 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Chief SSM225? Ask your question here

Chief SSM225 specifications

General
Brand Chief
Model SSM225
Product Projector accessory
Language English
Filetype PDF
Features
Brand compatibility Panasonic
Compatibility PT serie
Product colour Black