SSB-273, SSM-273, SLB-273 and SLM-273 Interface Brackets
SSB-273, SSM-273, SLB-273 and SLM-273 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING:IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
WARNING:OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE:Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1.Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2.Turn projector upside down on a flat surface.
3.Place two spacers onto the bottom of the projector, aligning with two mounting holes in the main body of bracket and the threaded inserts
in the bottom of the projector and ensuring that triangle in bracket points towards front of projector.
4.Position two M4 x 25mm mounting screws with M4 flat washers through the spacers and into the threaded inserts. Place three M4 x 12mm
screws with M4 flat washers into the threaded inserts and mounting holes on interface bracket tabs. Tighten all fasteners at this time,
securing the bracket to the projector.
NOTE:Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions
in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket(3) Screw, Phillips Pan Head, Machine, M4 x 12mm
(4) 10-24 Thumb Nuts **(2) Screw, Phillips Flat Head, Machine, M4 x 25mm
(1) All-Points Security Kit(2) Spacer, .500 x .316 x .500
(1) 5/32" Security Hex Key(5) Washer, Flat, M4
**Only used when installing SLB/SSB interface brackets.
NOTE:Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.
Note: SSB-style interface bracket connections are circled.Note: SSM-style interface bracket connections are circled.
Got a question?
Number of questions: 0
Do you have a question about the Chief SSM273 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Chief SSM273 owners to properly answer your question.
About the Chief SSM273
View the manual for the Chief SSM273 here, for free. This user manual comes under the category Projector accessories and has been rated by 1 people with an average of a 9.1. This manual is available in the following languages: English. Do you have a question about the Chief SSM273? Ask your question here