SSB-420, SSM-420, SLB-420 and SLM-420 Interface Brackets
SSB-420, SSM-420, SLB-420 and SLM-420 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING:IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
WARNING:OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE:Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place .25" nylon spacers over the threaded inserts in the bottom of the projector.
4.Place the interface bracket onto the nylon spacers in the bottom of the projector and align the holes in the bracket with the threaded inserts
in the bottom of the projector.
5.Position M4 x 16mm Phillips mounting screws with M4 flat washers into the back mounting holes, and place the M4 x 16mm flat head
mounting screw into the front mounting hole. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE:Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Spacer, Nylon, .5 x .218 x .25
(3) 10-24 Thumb Nuts ** (1) Screw, Flat head, M4 x 16mm
(1) All-Points Security Kit (2) Screw, Phillips Pan Head, M4 x 16mm
(2) Washer, Flat, M4
**Only used when installing SLB/SSB interface brackets.
NOTE:Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
Towards front of
Towards front of
Got a question?
Number of questions: 0
Do you have a question about the Chief SSM420 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Chief SSM420 owners to properly answer your question.
About the Chief SSM420
View the manual for the Chief SSM420 here, for free. This user manual comes under the category Projector accessories and has been rated by 1 people with an average of a 8.4. This manual is available in the following languages: English. Do you have a question about the Chief SSM420? Ask your question here