Chief SSM4200 manual

Chief SSM4200
(1)
  • Number of pages: 1
  • Filetype: PDF
  • INSTALLATION INSTRUCTIONS

    Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
    no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
    of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
    implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
    Chief Manufacturing, a products division of Milestone AV Technologies8401 Eagle Creek Parkway, Savage, MN 55378• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
    8802-002021 Rev01
    ©2009 Milestone AV Technologies,
    a Duchossois Group Company
    05/09

    SSB-4200, SSM-4200, SLB-4200 and SLM-4200 Interface Brackets

    SSB-4200, SSM-4200, SLB-4200 and SLM-4200 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the
    specific installation instructions provided with the mount for additional installation information.
    Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
    WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

    Installation Instructions

    WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing Interface bracket.
    NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
    1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.2. Turn projector upside down.3. Interface bracket should be centered on projector.4. Attach the U-Form rods around the projector and up through the holes in the interface bracket plate,
    5. Using the #10 flat washers and 10-24 Nylock nuts, secure interface bracket to projector and tighten all fasteners at this time.
    NOTE: Felt squares are provided to protect projector shell, if desired. They can be attached to the projector or wrapped around the U-Form
    rod. Security screws can be substituted when mounting interface bracket to projector by using the parts and installationinstructions in the All-Points Security Kit.Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.(1) Interface Bracket (8) Felt Squares(6) 10 - 24 Thumb Nuts** (2) U-Form Rods(1) All-Points Security Kit (4) #10 Flat Washers(4) 10-24 Nylock Nuts**Only used when installing SLB/SSB interface brackets.
    NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
    encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
    interface bracket installation.
    Towards front of
    projector
    Towards front of
    projector
    SLB-4200 SLM-4200
    (Note
    : SSM-style
    inter
    face b
    racke
    t conn
    ection
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
    (Note:
    SSB
    -style
    interfa
    ce br
    acket
    conne
    ction
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
Chief SSM4200

Got a question?

Number of questions: 0

Do you have a question about the Chief SSM4200 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Chief SSM4200 owners to properly answer your question.

View the manual for the Chief SSM4200 here, for free. This user manual comes under the category Projector accessories and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Chief SSM4200? Ask your question here

Chief SSM4200 specifications

General
Brand Chief
Model SSM4200
Product Projector accessory
Language English
Filetype PDF
Features
Brand compatibility Any brand
Product colour Black
Compatibility Boxlight, EIKI, Sanyo, Vidikron
show more

Frequently asked questions

Below, you will find the most frequently asked questions about the Chief SSM4200.

Is your question not listed? Ask your question here